According to the requirements of operation guidance, accumulation is not allowed, and it is necessary to place them in the workstation equipment one by one;

Cold chamber die casting can be used when die casting metals that cannot be used in the hot chamber die casting process, including aluminum, magnesium, copper, and zinc alloys with higher aluminum content.

After the molten metal enters the mold, the parting surface should not be closed immediately, and the overflow groove and the exhaust groove should not directly impact the mold core. The flow direction of the molten metal after entering the mold is as far as possible along the cast ribs and heat sinks, filling from the thick wall to the thin wall, etc.

The entrance of the runner of the cold horizontal mold should generally be located at more than 2/3 of the inner diameter of the upper part of the pressure chamber, so as to prevent the molten metal in the pressure chamber from entering the runner prematurely under the action of gravity and starting to solidify in advance.

The advantages of Die casting processing manufacturers include excellent dimensional accuracy of castings. Usually this depends on the casting material, typical values are 0.1mm error at the first 2.5cm size and 0.002mm error for every 1cm increase.

The optical module china Zinc alloy die casting die includes a main body and a base, a mold is provided at the lower end of the pressing plate, a sliding groove is provided on the outer wall of the lower end of the sliding rod, and the sliding rod is connected with the sliding groove by clamping.